Everstart Battery Charger 60108m Manual Jun 2026

Select the . For the safest, most effective charge that prolongs battery life, use the 2A trickle charge setting.

The 60108m is not a simple "dumb" charger. It includes microprocessors for automatic operation. Here is what the unit offers:

Wipe the copper clamps clean after every use. If they have acid residue on them, clean them with a paste of baking soda and water, then dry thoroughly to prevent corrosion. everstart battery charger 60108m manual

EverStart 60108M is a smart digital battery charger that features a back-lit dot matrix screen and three charging rates: (trickle), (rapid), and (large batteries/marine). Operating Instructions Connection : Ensure the charger is off. Connect the to the positive (+) battery terminal and the black clamp to the negative (–) terminal.

| Symptom / Display | Meaning | Solution | | :--- | :--- | :--- | | | Reverse polarity (clamps are swapped). | Immediately disconnect. Swap the red and black clamps. | | "F03" Error | Short circuit in the battery (dead cell) or clamps touching. | Inspect clamps for frayed wires. Test battery with a hydrometer or voltmeter. Battery may be scrap. | | "F07" Error | Charger cannot desulfate the battery (battery has been dead too long). | Try a manual "dumb" charger to shock the battery, or replace the battery. | | Flashing 0.0V | No voltage detected – clamps not making good contact. | Clean battery terminals. Squeeze clamps tighter. | | Charger hums loudly | Normal during high-rate (40A) charging. | No action needed. | | Display shows "FUL" but battery won't crank engine | Battery has voltage but no cranking amps (failed internal cell). | Battery is dead. Replace it. The charger is working correctly. | | Green light blinking but not charging | Charger is in "Abort" mode. Battery is sulfated or too low to accept a charge (<1V). | Try connecting a known good battery in parallel for 5 minutes to raise voltage, then retry. | Select the

: Slide the battery into the spring-loaded holder until the pins make firm contact with the terminals. The holder will lock the battery in place.

When charging is complete, , remove the black chassis clamp, and then remove the red battery clamp. Using the Engine Start Feature It includes microprocessors for automatic operation

The order of connection is vital for safety to prevent sparks.