Hanmatek Dos1102 Manual Jun 2026

Before first use, you should connect your probe to the calibration terminal (usually a 1 kHz square wave) and adjust the compensation trimmer until the wave is flat. Measurement Modes:

The DOS1102 features a USB port on the front. You can save screenshots (BMP) or waveform data (CSV) directly to a flash drive for reports or further analysis on a PC. Math Functions: hanmatek dos1102 manual

Practical counsel arrives as everyday wisdom. “Set the coupling,” the manual suggests, as simply as one would advise closing a window to block noise. “Adjust the trigger,” it recommends, like coaching someone to focus their gaze. Each instruction is concise but warm, never condescending—an invitation to experiment rather than a rigid recipe. Short how-tos live beside diagrams that look like tiny cityscapes of connectors and ports, each labeled as if to say, “This is where discovery begins.” Before first use, you should connect your probe

: Toggle channels on or off and open the specific channel menu. Each instruction is concise but warm

Before looking at third-party sites, always try the official source. Hanmatek does not have a vast centralized support portal, but the manual is typically available through:

: USB Device and Host interfaces for PC communication and U-disk data storage. 2. Initial Setup and Safety

Move the selected waveform up or down on the screen.