Ericsson Mini Link Cli Commands Hot!

MINI-LINK# show interfaces summary # All ports, speed, admin/oper status MINI-LINK# show interface eth0 # Detailed: MAC, duplex, errors, drops MINI-LINK# show interface eth0 statistics # Rx/Tx octets, unicast, multicast, CRC errors

show version : Outputs the current running software release, bootloader version, and backup software bank details.

show radio-link detail — Displays current transmit (TX) power, receive (RX) signal level, and modulation status.

This guide provides a comprehensive technical overview of essential CLI commands for Ericsson MINI-LINK systems, focusing on MINI-LINK TN, CN, and LH platforms running IP-based software. Accessing the Ericsson MINI-LINK CLI

Provisions Layer 2 traffic traffic, maps user data to specific VLANs, and configures trunk or access ports. IP and Routing Configuration ericsson mini link cli commands

This is the most frequently used command during troubleshooting. It lists all currently active issues on the node.

SET VLAN ID=<VLAN_ID>, PORT=<PORT_ID>, TAGMODE=<TAGGED|UNTAGGED>

| Command | Description | |---------|-------------| | show radio link | Overall link status (RSSI, Tx/Rx power, modulation) | | show radio interface <id> | Detailed radio interface parameters | | show radio performance | BER, MSE, errors, counters | | show radio adaptive-modulation | Adaptive modulation status & current profile | | show radio atpc | Automatic Transmit Power Control status | | show radio alarms | Active radio alarms (LOS, LOF, high BER) | | radio loopback set <local/remote> | Set radio loopback for testing | | radio loopback clear | Remove loopback |

show temperature — Checks the thermal status of the plug-in units and outdoor units (ODUs). MINI-LINK# show interfaces summary # All ports, speed,

For deeper analysis, the CLI supports syslog and event monitoring: Mini-Link CLI | PDF - Scribd

show radio Link : Displays the operational status, actual transmit power, and received signal level (RSL) of the microwave link.

MINI-LINK(config)# interface eth0 MINI-LINK(config-if-eth0)# loopback line # Towards line (near-end) MINI-LINK(config-if-eth0)# loopback internal # Towards switch fabric

: Tests connectivity to the far-end terminal or gateway. Accessing the Ericsson MINI-LINK CLI Provisions Layer 2

To force or restrict Adaptive Modulation (e.g., forcing the link to stay at a lower modulation for stability):

: A specialized command to reveal "hidden" or advanced debugging commands.

These commands are used to configure radio links, VLANs, and IP interfaces. Radio Link Configuration (MMU - Modem Management Unit)