Xycd60 Manual Jun 2026

(like the XY-CD63) to help you pick the best one for your needs.

The relay closes and charging begins when the battery voltage drops to or below the Lower Limit (dn) Deactivation:

The is a dual-function battery controller module designed for DC 6V–60V systems. It acts as an automated switch to protect lead-acid or lithium batteries from overcharging and over-discharging by managing the connection between a power source (charger), the battery, and the load. Core Specifications Voltage Range: DC 6V to 60V. xycd60 manual

The is an intelligent, dual-mode voltage control relay designed to protect batteries from overcharging and over-discharging . Operating across a wide voltage spectrum of DC 6V to 60V , this microcontroller-based module serves as an automated switch to safeguard lead-acid, lithium iron phosphate (LiFePO4), and standard lithium-ion battery banks.

Note to readers: This guide is based on aggregated user manuals, reverse engineering, and practical experience. Always consult a professional for critical measurements in aerospace, medical, or safety-critical applications. (like the XY-CD63) to help you pick the

The delay time before the relay activates (0-999 seconds). FOP (Force Open): Used to toggle continuous load output. Mode Switching (Charge vs. Discharge) Long-press the UP button for 5 seconds to switch modes.

Connect to your Battery (if in charge mode) or Load (if in discharge mode). Core Specifications Voltage Range: DC 6V to 60V

Before we dive into the manual, let's take a brief look at what the Xycd60 is. The Xycd60 is a state-of-the-art device designed to provide users with a unique and innovative experience. Whether you're using it for personal or professional purposes, the Xycd60 is a powerful tool that can help you achieve your goals.

30A (Requires appropriate cooling for sustained high loads). Control Precision: 0.1V. Work Modes: Charging Mode (IN), Discharging Mode (OUT).

| Symptom | Likely Cause | Solution (from repair logic, not always in manual) | |---------|--------------|------------------------------------------------------| | | Auto power-off | Press ON/OFF. If nothing, replace battery. | | Numbers jump rapidly when idle | Dirty capacitive strip inside scale | Open jaws, use compressed air to blow out debris. Do not oil. | | Reading changes when you thumb the roller | Loose sliding jaw or worn spring | Tighten the small adjustment screw on the back of the jaw. Turn 1/8th clockwise. | | Inches reading shows, but mm doesn’t | Stuck mode button | Gently press the mm/inch button 2-3 times. If no response, battery is low. | | Error code "E" or "Err" | Electronic failure or low voltage | Replace battery with a new LR44 (not from an old multi-pack). If persists, circuit board is damaged. | | Negative reading when jaws are closed | Zero drift | Clean jaws, close firmly, then press ZERO. | | Fluctuating last digit | Hand temperature or air current | This is normal (±0.02mm). Stabilize for 10 seconds before reading. |

Sets a timer for how long the output remains active.