TS1162 Tape Drive Installation Guide: Setup, Integration, and Best Practices
The you plan to load (e.g., Type D, Type E cartridges) Your primary host interface type (Fibre Channel or SAS)
The is engineered to provide superior, reliable performance for your critical applications. To achieve the maximum efficacy and longevity of this unit, a precise, compliant installation is mandatory. This exclusive guide offers an expert overview of the installation process, moving beyond standard documentation to provide specialized technical insights. 1. Pre-Installation Preparation: The Foundation of Success
links directly to the Challenger multi-drop RS-485 Local Area Network (LAN). For optimal signal performance, use high-grade 2-pair data cables or Cat5e/Cat6 data wiring.
If the provided hose is too short, use a 1/2” rigid PVC pipe to extend it. Ensure the extension maintains a downward slope toward the drain. 3. Electrical Requirements Power Source: Use a standard 115V, 60Hz outlet. ts1162 installation manual exclusive
CHALLENGER PANEL RS-485 LAN TERMINALS ┌───────┐ ┌───────┐ ┌───────┐ ┌───────┐ │ +12V │ │ GND │ │ D+ │ │ D- │ └───┬───┘ └───┬───┘ └───┬───┘ └───┬───┘ │ │ │ │ │ (Red) │ (Black) │ (White) │ (Green) │ │ │ │ ┌───┴───┐ ┌───┴───┐ ┌───┴───┐ ┌───┴───┐ │ +12V │ │ GND │ │ D+ │ │ D- │ └───────┘ └───────┘ └───────┘ └───────┘ TS1162 KEYPAD LAN TERMINAL BLOCK RS-485 LAN Bus Connections
The Tecom TS1162 is an IP67-rated 3-LED Remote Arming Station that connects via RS-485 to Challenger security systems, allowing for remote arming/disarming and Request to Exit (RTE) functionality. Installation involves mounting the unit to a flat surface, wiring via the RS-485 LAN, and configuring addressing via DIP switches. For more information, visit Aritech Support Portal Remote Arming Station (RAS) Keypad, 3 LED - Aritech
Always connect the green/yellow ground wire first to prevent static buildup or surges.
Use the provided mounting template to mark your pilot holes. If the provided hose is too short, use
Use the onboard buttons to set your target relative humidity (RH). A common starting point is 50% .
Open the cover of the time switch. You will see four main terminal screws (usually brass or silver):
: All power to the Challenger panel should be turned off before wiring the RAS. Addressing
Secure the mounting bracket firmly, ensuring it is level. Remote Arming Station (RAS) Keypad
(typically switches 1–4 for address and switch 8 for termination) before reattaching the body to the base. aritech.com.au Key Technical Specifications Environmental Rating : IP67 (Dust-tight and waterproof). Compatibility : Challenger series (Challenger10, ChallengerPlus). : Supports cabling up to 1.5 km. Ness Corporation DIP switch address table or information on how to register for the Aritech Certified Installer Portal to get the full PDF? Remote Arming Station (RAS) Keypad, 3 LED - Aritech
The standard TS1162 manual lists error codes E01 through E12. Through reverse engineering and field data from over 2,000 installations, we have discovered :
Configure your SAN switch zoning to place the host Bus Adapter (HBA) World Wide Port Names (WWPNs) and the TS1162 WWPNs into the exact same zone.