Evoko Liso Factory Reset Verified [better]

The device will boot into the "Installation Wizard" screen. Method 2: Reset via the Admin Menu

Confirm the prompt. The device will wipe its local cache, disconnect from the Evoko Home server, and reboot into the initial setup wizard. Method 3: Remote Reset via Evoko Home Server Panel

Navigate to the System or Network settings submenu within the administrator panel. Trigger Reset: Tap on Reset Device or Factory Reset .

Copy the raw files directly to the root directory of the MicroSD card. Do not put them inside a folder. Phase 2: Flash the Hardware evoko liso factory reset verified

This is the only method recognized by Evoko/Biamp to perform a full device reset. Carefully follow these steps, which have been verified against official guides.

While holding the button, plug the power cable back into the device.

Before starting the reset process, gather the necessary equipment and back up essential data. A factory reset wipes all local configurations, including IP addresses, certificates, and server connection strings. The device will boot into the "Installation Wizard" screen

After a reset, the device might revert to an older firmware version. Always check for available updates via the Evoko Home "Global Properties" tab to ensure your hardware remains secure. Summary Key Points 💡 Use the pinhole for 10-15 seconds. Software Reset: Use the Admin Menu if the PIN is known.

Gather the following items before you begin:

After completing the reset, the Liso's previous network settings, room assignments, and Evoko Home connection will be erased. You will need to set it up from scratch as a new device. Method 3: Remote Reset via Evoko Home Server

(If referring to a single, non-specific verification event.)

Tap the or the clock icon in the top corner of the screen to open the administration menu.

: Once Etcher completes the process and verifies the image, the drive name should change (e.g., "Boot imx6dl"). Ignore any Windows prompts asking to format the drive after flashing. Biamp Cornerstone Execution: Performing the Factory Reset Power Down : Turn off the Evoko Liso by removing its (Power over Ethernet) or power cable. Insert USB

The screen will display a progress bar or text indicating the firmware is flashing. Do not remove power during this process. The device will reboot automatically to the initial configuration screen once complete. Method 2: The Admin Evoko Home Menu Reset