Lossless Scaling V2.10.1 -

: It works on almost any windowed application, making it a "must-have" for handhelds like the Steam Deck or ROG Ally. 🛠️ Pro Tips for v2.10.1

Because the software must process frames before sending them to the screen, a small amount of latency is introduced. Minimize this by:

The core breakthrough of the v2.10.1 revision is its optimization of the game-agnostic pipeline. Where previous versions suffered from user-interface (UI) flickering or aggressive input delay, v2.10.1 systemizes stability through three primary engineering upgrades: 1. Refined LSFG 2.2 UI Detection

While Frame Generation steals the spotlight, v2.10 also refined the upscaling aspect. Lossless Scaling v2.10.1

Use DXGI for the best overall frame pacing and lower latency.

Turn off VSync within the game settings to prevent conflict with the software's scaling.

: The mouse cursor now matches your generated FPS, eliminating that "heavy" feeling. : If you're using an AMD GPU, try setting Max Frame Latency to 3 for the best balance of stability and performance. 🛠️ Quick Setup Guide Window Mode : Run your game in Windowed or Borderless Windowed mode. Turn Off In-Game VSync : Let Lossless Scaling handle the frame pacing. Scale Mode for frame generation and for general upscaling. The "Scale" Button : It works on almost any windowed application,

The Steam Community 2.10.1 Patch Notes highlighted critical changes to target these issues:

Based on typical update patterns for this tool (actual changes may vary – always refer to official notes):

Resource utilization has been optimized, freeing up valuable GPU and CPU cycles. This ensures that the overhead of running the utility does not negate the performance gains achieved by frame generation. How to Set Up Lossless Scaling v2.10.1 Turn off VSync within the game settings to

: The options for "VSync" and "Allow Tearing" have been merged into a single dropdown menu for better usability.

Image quality and scaling behavior

30 FPS (60 FPS output). Recommended base is 40–60 FPS. Minimum Base for X3: 40 FPS (120 FPS output). Combating Input Lag

: For the best frame pacing, users should cap their base FPS (using RTSS or in-game settings) to exactly half (for X2) or one-third (for X3) of their monitor's refresh rate.

[ Game Output (Windowed) ] │ ▼ [ Lossless Scaling v2.10.1 ] ──► (Applies LS1/FSR Spatial Upscaling) │ ▼ [ LSFG 2.3 Engine ] ───────────► (Analyzes optical flow & injects intermediate frames) │ ▼ [ Monitor Display (Full Screen) ] Step-by-Step Configuration Guide