Arduino Sensor Shield V5 0 Manual Free Jun 2026

Servos use standard 3-pin connectors that line up perfectly with the shield.

: Configured specifically for HC-05/HC-06 modules.

Open the Arduino IDE and upload a simple “Blink” sketch (which uses pin 13). The yellow LED labelled “L” on the shield (connected to D13) should start blinking. This confirms that the shield is passing signals and power correctly. arduino sensor shield v5 0 manual

A 4-pin header mapped to Tx, Rx, 5V, and GND for HC-05 or HC-06 modules.

I can provide a custom wiring map and a sample Arduino sketch tailored to your build. Share public link Servos use standard 3-pin connectors that line up

Every digital pin features a 3-pin header for easy connection to modules like servos, relays, and digital sensors. Analog I/O Ports (A0–A5):

Beyond the standard SVG rows, the Sensor Shield V5.0 includes specialized headers for popular modules: The External Power Jumper (SEL) The yellow LED labelled “L” on the shield

: All digital (D0–D13) and analog (A0–A5) pins are arranged in 3-pin stacks: Top (GND) , Middle (VCC) , and Bottom (Signal) .

All digital and analog pins are powered by the Arduino's internal 5V regulator . This is suitable for low-power sensors but can be overloaded by multiple servos.

Locate the dedicated 4-pin header on the edge of the shield. Connect GND to G , VCC to V , SDA to SDA , and SCL to SCL .