K3ng Keyer Schematic [patched] -

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. Using the K3NG Arduino CW Keyer with N1MM Logger+

Building the K3NG Keyer requires basic electronics skills and knowledge of soldering. The keyer can be built on a breadboard or a PCB (Printed Circuit Board).

Here's a simplified block diagram of the K3NG keyer schematic:

Arduino Nano +5V -----[10k]-----+----[Paddle Dah]---- GND | +----[Paddle Dit]----- GND k3ng keyer schematic

You must isolate the Arduino from your radio. Connecting the pin directly to the radio can damage the Arduino or the radio.

K3NG Keyer is a highly versatile, open-source CW (Morse code) keyer based on the Arduino platform, developed by Anthony Good (K3NG). Because of its modular nature, there isn't just one single "master" schematic; instead, the design scales from a simple two-paddle interface to a complex station controller with LCDs, keyboards, and multiple radio outputs. 1. Core Circuit Components

Adding a display is optional, but it greatly enhances the usability of the keyer. The schematic must connect the LCD’s data and control lines to specific Arduino pins. The K3NG software supports both 4‑bit parallel LCDs and I²C‑backpack LCDs, the latter requiring only two wires (SDA and SCL) for communication. This public link is valid for 7 days

Note: No resistors are needed for the paddles because the code uses internal pull-ups. 3. Keyer Output (To Transceiver)

Connect Pin 4 and Pin 5 (Emitter and Collector of the output transistor) to your radio’s key jack. Note: Ensure polarity matches your rig's manual.

The K3NG keyer is an electronic device that generates a precise CW signal for amateur radio transmission. It's designed to be highly customizable, allowing users to adjust various parameters such as keyer speed, tone, and paddle settings. The K3NG keyer is widely used among amateur radio operators due to its reliability, ease of use, and flexibility. Can’t copy the link right now

For those seeking a more defined path, the project by N7XG offers a fantastic, ready-to-use schematic and PCB. This popular variant is built around an Arduino Nano 3.0 and includes a 5V Mini-360 buck regulator for power input, LEDs, headers, and built-in transistor drivers for keying. The full schematic is available in its manual. The parts list from the nKeyer gives specific values that are a great starting point for understanding the component requirements of a K3NG keyer.

A 3.5 mm stereo jack is connected as: tip → DIT (e.g., pin D2), ring → DAH (e.g., pin D5), sleeve → GND. The schematic often includes a 10 kΩ resistor from each paddle pin to +5 V and a 10 nF capacitor to ground for debouncing.