Skope Heated Towel Rail Timer Instructions //top\\ -

Use the Set/Program button to select the "ON" time, then use the arrows to set when you want the rail to start heating (e.g., 6:30 AM).

Check your main household switchboard to ensure the bathroom heating circuit breaker is ON. If the power has been off for a long time, let the unit charge for 10 minutes to see if the display revives. The Towel Rail Does Not Turn On in AUTO Mode Cause: Incorrect AM/PM settings or overlapping programs.

: Runs for 4 hours on / 8 hours off twice daily.

: Towel rails generally require 15 to 30 minutes to reach full operating temperature. skope heated towel rail timer instructions

Watch this guide for a visual walkthrough on programming digital timers for towel rails:

A heated towel rail adds comfort and luxury to your bathroom. However, leaving it running continuously wastes electricity and shortens the lifespan of the heating element. Integrating a timer ensures your towels are warm right when you need them while keeping your energy bills low.

If the mains power is on but the screen is blank, the internal backup battery may be dead. Leave the unit powered on for a few hours to recharge it, or consult your manual regarding battery replacement. The schedule triggers at the wrong time Use the Set/Program button to select the "ON"

Before programming a schedule, the internal clock must match your local time. Press and hold the or SET button.

Benefit: Maximizes comfort for households with varied bathing schedules while keeping the rail off during peak energy cost hours in the middle of the day. Troubleshooting Common Timer Issues The Towel Rail is Cold but the Timer Says "ON"

Press the CLOCK button or wait 15 seconds for the screen to return to the main display. Switching Between Auto and Manual Modes The Towel Rail Does Not Turn On in

Use the 3-hour timer before your known shower time.

: Runs for 6 hours on / 6 hours off daily.

If your Skope unit has a multi-button digital display (like the TRTS series), use these steps to set a custom schedule: 1. Set the Current Time Tap the until it flashes. Use the Up/Down Arrows to adjust hours and minutes. Select the correct Day of the Week . Press Done or Clock to save. 2. Program the Heating Schedule Select Auto Mode and press the Schedule (or PROG) button.

Ensure the controller is set to AUTO and not stuck in a manual "OFF" state.