Narishige Pc10 Manual New !link! ⟶

Located at the bottom of the lower slider shaft. Removable ring weights allow users to modify the gravitational pulling force.

The first heating cycle softens the glass for a primary elongation (tapering).

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. narishige pc10 manual new

: Approximately 80W, compatible with various AC voltages (100V–240V) depending on internal settings.

The Narishige PC-10 manual is a comprehensive guide that provides users with detailed information on the instrument's operation, maintenance, and troubleshooting. The manual covers essential topics such as: Located at the bottom of the lower slider shaft

The glass capillary must sit perfectly centered inside the platinum loop. If the capillary leans closer to one side of the coil, one side of the glass will melt faster, resulting in bent or hooked pipette tips. Loosen the coil mounting screws to manually center the loop if necessary. Troubleshooting Matrix Probable Cause Corrective Action Off-center heating coil or uneven airflow. Center the coil; shield the unit from drafts. Glass breaks instantly Heater setting is too low; weight is too heavy. Increase the heater dial value incrementally. No heat generated Burned-out platinum coil or blown fuse. Inspect the coil for breaks; check the rear fuse. Inconsistent tip sizes Variations in glass OD or sliding friction. Clean the vertical guide rods with a dry cloth.

Set the dial to control the final velocity. Higher magnet settings create smaller tips and longer tapers. Step 4.3: Executing the Pull This public link is valid for 7 days

For a precision instrument like the PC-10, the manual is more than a guide; it is a comprehensive reference. It contains crucial information essential for safe and effective operation, including: